Skip to main content
24" 40-Pin 80-Wire Ultra ATA 2-Drive Ribbon Cable, Manhattan 332781, Model:, Electronic Store
MANHATTAN

24" 40-Pin 80-Wire Ultra ATA 2-Drive Ribbon Cable, Manhattan 332781, Model:, Electronic Store

Bottom line: The MANHATTAN 24" 40-Pin 80-Wire Ultra ATA 2-Drive Ribbon Cable: 80-wire design supports Ultra ATA/100 and Ultra ATA/66 transfer modes; main trade-off: IDE/PATA only; SATA drives need a separate adapter.

Check price on Amazon

As an Amazon Associate, SpecPicks earns from qualifying purchases. Full disclosure →

Mike Perry — Hardware researcher since 2014. For retro PC hardware and period-correct parts, synthesises manufacturer documentation, community compatibility lists and marketplace listings rather than first-hand lab testing. Core beat: GPU performance across gaming, rendering, and local-LLM inference.

Pros & Cons

Pros

  • ✓ 80-wire design supports Ultra ATA/100 and Ultra ATA/66 transfer modes
  • ✓ 3 connectors run 2 IDE devices, such as a hard drive plus a CD-ROM, on one channel
  • ✓ 24-inch length reaches distant drive bays in mid-tower and full-tower cases
  • ✓ Backward compatible with Ultra ATA/33 and DMA modes on older motherboards
  • ✓ Direct replacement for brittle or nicked original ribbons in retro PC restorations

Cons

  • ✗ IDE/PATA only; SATA drives need a separate adapter
  • ✗ 24 in is longer than the 18 in ATA spec maximum, so some controllers may be sensitive to it
  • ✗ Wide flat ribbon can block airflow in cramped cases unless routed carefully
  • ✗ Limited to 2 devices per cable; a third drive needs another IDE channel

Manufacturer description

Reviving a late-1990s tower or replacing the cracked ribbon in an old IDE build? The Manhattan 332781 is a 24-inch, 40-pin, 80-wire Ultra ATA ribbon cable that connects up to two EIDE/IDE devices to a single motherboard channel. It has three connectors: one for the host and two for devices. That lets you run a hard drive and a CD-ROM drive, or two hard drives, from one IDE port. The 80-wire design is the reason to pick this cable over an older 40-wire one. Ultra ATA/66 and Ultra ATA/100 transfer modes need the extra ground conductors placed between the 40 signal lines. Manhattan rates this…

SpecPicks Verdict

SpecPicks has no buyer-rating or benchmark data for MANHATTAN 24" 40-Pin 80-Wire Ultra ATA 2-Drive Ribbon Cable, so this read rests on the manufacturer's listed specs (how we evaluate). Compare with similarly-priced alternatives in the cables & connectors category before committing. On the listing's own facts, the case for it is "80-wire design supports Ultra ATA/100 and Ultra ATA/66 transfer modes"; the main trade-off is "IDE/PATA only; SATA drives need a separate adapter". If those two points fit how you will use it, put it beside one or two close alternatives in the Compare tool to confirm the price.

Before ordering, check the listed dimensions, ports, power requirements and supported devices or systems in the spec table below against how you plan to use it, and confirm them on the retailer's listing. Prices and stock are set by the retailer and may have moved since this page was last updated.

Frequently Asked Questions

Will this cable run my hard drive at Ultra ATA/100 speeds?

Yes, if your controller and drive support it. The Manhattan 332781 is an 80-wire cable rated for Ultra ATA/100, Ultra ATA/66, Ultra ATA/33 and DMA modes.

How many drives can I connect with one cable?

Two. The cable has 3 connectors: one plugs into the motherboard or controller, and the other two connect EIDE/IDE devices such as a hard drive and a CD-ROM drive.

Does it work with IDE CD-ROM drives as well as hard drives?

Yes. Manhattan lists compatibility with EIDE/IDE hard drives and CD-ROM drives. You can mix one of each on the same cable.

How long is the cable?

It is 24 inches long. That gives you more reach than shorter IDE ribbons, which helps when the drive bays sit far from the motherboard IDE header.

Can I use this cable with SATA drives?

No. This is a 40-pin parallel ATA (IDE) cable. SATA drives use a different connector and need a separate SATA cable or an IDE-to-SATA adapter.

Key Features

Quoted from the manufacturer's listing. Where it differs from the pros and cons above, those note the conditions the listing leaves out.

  • For Ultra ATA/100, Ultra ATA/66, Ultra ATA/33 and DMA, and with EIDE/IDE hard drives & CD-ROM drives
  • 24" Ultra IDE 80-Wire Ribbon Cable
  • 3 Connectors for 2 Devices

Full Specifications

BrandMANHATTAN
ColorGrey
ModelEL-PN-47307755
Cable TypeIDE Cable
Model NameEL-PN-47307755
Unit Count1 Count
Part NumberEL-PN-47307755
Connector TypeIde
Number of Pins40
Maximum Voltage5 Volts
Special FeatureFlat Ribbon Cable
Connector GenderMale-to-Male
Compatible DevicesIDE Hard Drives
Indoor Outdoor UsageIndoor
Recommended Uses For Product40-Pin IDE Devices
Other Special Features of the ProductFlat Ribbon Cable

Ready to buy?

24" 40-Pin 80-Wire Ultra ATA 2-Drive Ribbon Cable, Manhattan 332781, Model:, Electronic Store is listed on Amazon. Price, availability, shipping and returns are set by Amazon and its sellers — check the listing for current terms. SpecPicks earns a small commission on qualifying purchases — thank you for supporting independent review work.

Check price on Amazon →

Related Cables & Connectors

More guides & deep dives from the SpecPicks archive

Browse all articles & guides →

More reviews from the SpecPicks archive

Browse all reviews →

Earliest SpecPicks reviews

Browse full archive →